Revision [9811]
This is an old revision of ArmorGuardian made by SturmWolke on 2012-04-08 02:40:44.
Guardian General Notes
A armor logistic ship that relies on energy transfer chaining to regenerate its capacitor.
Typical rigs choices revolves around Medium Ancillary Current Routers and Medium Remote Repair Augmentors.
There are two school of thoughts when fitting Guardians for incursion :
1) Classic fit for maximum tank, fully relying on energy transfer chain to maintain capacitor.
2) Novel fit for minimum stable repair capacity at 40-60% (2-3 RR) if/when energy transfer chain breaks.
The are various pros and cons for the above, with 2) edging it slightly in terms of advantages.
With 2), the Guardian fits can be standardized into a single fit, eliminating the differences between Logistic 4 and 5 pilot fits.
This simplifies logistic energy transfer management in any armor fleet.
Minimum skill (recommended) |
---|
- Logistics 4
- Remote Armor Repair Systems 5
- Energy Emissions Systems 4 (important for energy transfer efficiency)
- Multitasking 3 (allows 10 locked targets, no locking delay when changing rep target)
- Sensor Linking 4 (needed for T2 Tracking Links/Remote Sensor Booster)
Guardian Classic Basic (Vanguard Starter Cheap Fit)
Meta 4 RR | 1600mm plate |
Design Notes |
---|
- Cheap T2 fit for starters. Limited to T1 rigs.
- No implants required.
- Strong EM/Thermal resist profile (Kin/Exp torpedoes damage is already reduced to a negligible amount by the ship's small signature).
- The Damage Control module avoids being stacked nerfed against the resist bonus received from the armor gang links.
- Stable repair capacity is 25% (1 RR) without energy transfer.
- Logistic 5 pilots may swap out 1x Large Energy Transfers for another RR (5/1 configuration). Requires a faction PDS to fit.
Assault/Headquarter/Kundalini Manifest Notes
- Requires a faction PDS.
- Retrofitted to 1x Sensor Booster and 10MN Afterburner to improve lock time and survivability.
- Again, strong EM/Thermal resist profile (except for the Kundalini Manifest).
- For the Kundalini Manifest, remove 1x EM Hardener and retrofit with 1x EANM.
- Standard 4/2 configuration enable Logistic 5 Guardians to respond to fleet capacitor requests.
Ship Details | |
---|---|
Remote repair | 307 armor/s |
Drone repair | 35 armor/s - Light Armor Maintenance Bot II |
Armor resists | 81/75/68/83 (EM/Therm/Kin/Exp) |
Armor defence efficiency | 331 - repped by 1x Large Solace remote repair |
Armor | 7,886 |
EHP | 43,077 |
Scan resolution | 481-770mm |
Targeting range | 81km |
Speed | 261-596m/s |
Signature radius | 70m |
Capacitor state | Stable - 2x Large Energy Transfer, Logistic 4 |
High Power |
---|
4x Large 'Solace' I Remote Bulwark Reconstruction |
2x Large 'Regard' I Power Projector |
Medium Power |
2x Remote Sensor Booster II |
Low Power |
Damage Control II |
Power Diagnostic System II |
True Sansha Armor EM Hardener |
True Sansha Armor Thermic Hardener |
1600mm Reinforced Rolled Tungsten Plates I |
Rig Slot |
2x Medium Ancillary Current Router I |
Guardian Classic A (Vanguard/Assault/Headquarter Fit)
Meta 4 RR | 1600mm plate |
Design Notes |
---|
- Affordable build, adding faction modules and T2 rigs where necessary.
- No implants required.
- Strong EM/Thermal resist profile (Kin/Exp torpedoes damage is already reduced to a negligible amount by the ship's small signature).
- The Damage Control module avoids being stacked nerfed against the resist bonus received from the armor gang links.
- Logistic 4 pilots needs to receive 2x Large Energy Transfers to remain cap stable.
- Logistic 5 pilots may swap out 1x Large Energy Transfers for another RR (5/1 configuration).
Assault/Headquarter/Kundalini Manifest Notes
- Requires a minimum Squire EG-603 implant (3% powergrid) to increase powergrid for an afterburner.
- Retrofitted to 1x Sensor Booster and 10MN Afterburner to improve lock time and survivability.
- Again, strong EM/Thermal resist profile.
- Standard 4/2 configuration to enable Logistic 5 Guardians to respond to fleet capacitor requests.
Ship Details | |
---|---|
Remote repair | 307 armor/s |
Drone repair | 35 armor/s - Light Armor Maintenance Bot II |
Armor resists | 86/81/77/88 (EM/Therm/Kin/Exp) |
Armor defence efficiency | 449 - repped by 1x Large Solace remote repair |
Armor | 7,886 |
EHP | 55,115 |
Scan resolution | 481-770mm |
Targeting range | 81km |
Speed | 261-596m/s |
Signature radius | 70m |
Capacitor state | Stable - 2x Large Energy Transfer, Logistic 4 |
High Power |
---|
4x Large 'Solace' I Remote Bulwark Reconstruction |
2x Large 'Regard' I Power Projector |
Medium Power |
2x Remote Sensor Booster II |
Low Power |
Damage Control II |
Imperial Navy Energized Adaptive Nano Membrane |
True Sansha Armor EM Hardener |
True Sansha Armor Thermic Hardener |
1600mm Reinforced Rolled Tungsten Plates I |
Rig Slot |
Medium Ancillary Current Router I |
Medium Ancillary Current Router II |
Guardian Classic B (Vanguard/Assault/Headquarter Fit)
T2 RR | 1600mm plate |
Design Notes |
---|
- Expensive build, incorporating T2 RR.
- The CPU issue is solved by fitting A-type Adaptive Nano Plating (either Centii, Corpii or Coreli).
- Requires a minimum Squire EG-603 implant (3% powergrid).
- Strong EM/Thermal resist profile (Kin/Exp torpedoes damage is already reduced to a negligible amount by the ship's small signature).
- The Damage Control module avoids being stacked nerfed against the resist bonus received from the armor gang links.
- Logistic 4 pilots needs to receive 2x Large Energy Transfers to remain cap stable.
- Logistic 5 pilots may swap out 1x Large Energy Transfers for another RR (5/1 configuration).
Assault/Headquarter/Kundalini Manifest Notes
- Requires a minimum Squire EG-603 implant (3% powergrid) to increase powergrid for an afterburner.
- Retrofitted to 1x Sensor Booster and 10MN Afterburner to improve lock time and survivability.
- Again, strong EM/Thermal resist profile.
- Standard 4/2 configuration to enable Logistic 5 Guardians to respond to fleet capacitor requests.
Ship Details | |
---|---|
Remote repair | 341 armor/s |
Drone repair | 35 armor/s - Light Armor Maintenance Bot II |
Armor resists | 78/85/83/91 (EM/Therm/Kin/Exp) |
Armor defence efficiency | 487 - repped by 1x Large Solace remote repair |
Armor | 7,886 |
EHP | 58,954 |
Scan resolution | 481-770mm |
Targeting range | 81km |
Speed | 261-596m/s |
Signature radius | 70m |
Capacitor state | Stable - 2x Large Energy Transfer, Logistic 4 |
High Power |
---|
4x Large Remote Armor Repair System II |
2x Large 'Regard' I Power Projector |
Medium Power |
2x Remote Sensor Booster II |
Low Power |
Damage Control II |
2x Centii A-Type Adaptive Nano Plating |
True Sansha Armor Thermic Hardener |
1600mm Reinforced Rolled Tungsten Plates I |
Rig Slot |
2x Medium Ancillary Current Router II |
IncursionArmorWorkshop Back to Main Armor List